CORODUR® 60

NORMBEZEICHNUNG

DIN EN 14700 | DIN 8555
T Fe15 | MF 10-60-G

GENERAL CHARACTERISTICS

High C- Cr- Nb- alloyed flux- cored wire electrode for high abrasive wear up to 550 °C. The weld deposit consists of chrome - and niobium – carbides which are embedded into the matrix. The deposit should be subjected to little impact stress. Weld metal is not machinable. Maximum deposit should be limited to three layers and a thickness of 10 mm. Before overlaying sensitive base materials and old previously hardfaced surfaces a buffering layer of CORODUR 200 K or 250 K is recommended.

APPLICATION

Mixer paddles, grinding rollers and grinding paths, wear plates, band transfers, chutes, hoppers, cement and concrete pumps, excavator teeth, steel, coal, cement and mineral industry

TYPICAL ALL WELD METAL ANALYSIS (%):

C Si Mn Cr Nb
5,1 1,1 0,4 22,0 7,0

TYPICAL ALL WELD METAL MECHANICAL PROPERTIES

Hardness: 61 - 63 HRc

PARAMETER

Diameter Voltage Amps
1,2 18-27 140-240
1,6 20-27 160-280
2,0 22-26 220-300
2,4 24-27 260-340
2,8 25-28 320-440
3,2 26-30 350-520

FORMS OF DELIVERY

Coil "BS 300" = 15 kg Coil "BS 450" = 25 kg Drums = 300 kg

OA = gasless, SA = Submerged Arc


Corodur Fülldraht GmbH may change the characteristics of the wire without notice. Statements on composition and application are just for the applier's information. Statements on mechanical properties always refer to the all-weld-metal according to valid standards. We recommend the applier to check our products for their special application autonomously.

PDF Factsheet