DIN EN 14700 | DIN 8555
T Fe15 | MF 10-60-G
High C- Cr- Nb- alloyed flux- cored wire electrode for high abrasive wear up to 550 °C. The weld deposit consists of chrome - and niobium – carbides which are embedded into the matrix. The deposit should be subjected to little impact stress. Weld metal is not machinable. Maximum deposit should be limited to three layers and a thickness of 10 mm. Before overlaying sensitive base materials and old previously hardfaced surfaces a buffering layer of CORODUR 200 K or 250 K is recommended.
Mixer paddles, grinding rollers and grinding paths, wear plates, band transfers, chutes, hoppers, cement and concrete pumps, excavator teeth, steel, coal, cement and mineral industry
TYPICAL ALL WELD METAL ANALYSIS (%):
TYPICAL ALL WELD METAL MECHANICAL PROPERTIES
Hardness: 61 - 63 HRc
FORMS OF DELIVERY
|Coil "BS 300" = 15 kg||Coil "BS 450" = 25 kg||Drums = 300 kg|
OA = gasless, SA = Submerged Arc
Corodur Fülldraht GmbH may change the characteristics of the wire without notice. Statements on composition and application are just for the applier's information. Statements on mechanical properties always refer to the all-weld-metal according to valid standards. We recommend the applier to check our products for their special application autonomously.