CORODUR® SP 234

Flux cored wires for Thermal Spray Application

EN ISO 14919 – 6,5 – 1,6 - 4

MATERIAL REVIEW

Flux cored wire designed to be selfbonding for use as bond coat. Showing good acid resistance, oxidation resistance and good resistance against hot gas corrosion. Best bonding if applied in one pass (about 0,125 mm). Coating is easy to machine. Designed for arc spraying but may also be sprayed by wire- and high-velocity-wire-flame-spraying.

APPLICATION

Bond coat for repair of machine components with good oxidation and hot gas corrosion resistance.

Datasheet

CORODUR® SP 233

Flux cored wires for Thermal Spray Application

EN ISO 14919 – 6,5 – 1,6 - 4

MATERIAL REVIEW

Very high bond strength, also on smooth surfaces, self-bonding due to exothermic reaction, very dense coatings. Can be applied on clean but not sand blasted surfaces. Best bonding if applied in one pass (about 0,125 mm). Coating is easy to machine. Designed for arc spraying but may also be sprayed by wire- and high-velocity-wire-flame-spraying.

APPLICATION

Bond coat with good oxidation and high temperature resistance up to 650°C.

Datasheet

CORODUR® SP 232

Flux cored wires for Thermal Spray Application

EN ISO 14919 – 6 – 1,6 - 4

MATERIAL REVIEW

CORODUR SP 232 allows applying high quality corrosion resistant protective coatings without sintering or bond coat. The coating is dense with good bonding. It can be machined. Designed for arc spraying but may also be sprayed by wire- and high-velocity-wire-flame-spraying.

APPLICATION

Repair coating for worn out components.

Datasheet

CORODUR® SP 231

Flux cored wires for Thermal Spray Application

EN ISO 14919 – 5 – 1,6 - 4

MATERIAL REVIEW

Excellent bond strength due to exothermic reaction used as bond coats for repair of machinable C-steels and corrosion resistant steels. Good resistance against particle erosion and increased wear resistance due to Mo content. Designed for arc spraying but may also be sprayed by wire- and high-velocity-wire-flame-spraying.

APPLICATION

Application for bearing areas, and repair of parts out of tolerance or worn out components.

Datasheet