CORODUR® WZ 55
CLASSIFICATION
DIN EN 14700 DIN 8555
T Fe3 MF 3-55-STW
Alloy-No. 1.2662
GENERAL CHARACTERISTICS:
CORODUR WZ 55 is a flux cored wire which deposits an air hardening and wear resistant alloy and can be applied to reclaim hot-forging dies and to overlay the edges and flat areas of low alloyed high density steel tools. CORODUR WZ 55 is typically applied on: slab shears, hot-forging dies, drawing dies, containers, crushing equipment and depressions created by forging, pressure and
impact stress.
APPLICATION
Forging tools, hot shear blades
TYPICAL ALL WELD METAL ANALYSIS ( % ):
C | Si | Mn | Cr | Co | V | W |
0,35 | 0,8 | 1,2 | 3,0 | 2,0 | 0,5 | 7,0 |
TYPICAL ALL WELD METAL MECHANICAL PROPERTIES
Hardness: 53 - 56 HRc
Or thermoset hardening: 56 - 58 HRc
(1h of 500 - 550°C)
PARAMETER
Diameter | Voltage | Amps |
1,2 | 20-24 | 150-200 |
1,6 | 22-26 | 180-240 |
2,0 | 25-27 | 220-260 |
2,4 | 25-27 | 260-300 |
2,8 | 26-28 | 260-340 |
FORMS OF DELIVERY
Coil "BS 300" = 15 kg | Coil "BS 450" = 25 kg | Drums = 300 kg |
Corodur Fülldraht GmbH may change the characteristics of the wire without notice. Statements on composition and application are just for the applier’s information. Statements on mechanical properties always refer to the all-weld-metal according to valid standards. We recommend the applier to check our products for their special application autonomously.