CORODUR® SP 107

Flux cored wires for Thermal Spray Application

EN ISO 14919 – 5 – 1,6 - 4

MATERIAL REVIEW

Austenitic, corrosion resistant flux cored wire alloy, with increasing hardness in service and being non-magnetic. Good machinability. Designed for arc spraying but may also be sprayed by wire- and high-velocity-wire-flame-spraying

APPLICATION

Used for repair of all kinds of machinery components.

COMPOSITION (Weight-%)

Fe Cr Ni Si Mn C
Bal. 19 8,5 0,4 6 0,1

PHYSICAL PROPERTIES OF THE COATING

Hardness: 400 HB
Melting point: ca 1430 °C
Density: 6,9 g/dm3
Spray rate: 4,5 kg/h / 100 A
Wire consumption 1,0 kg/m2 / 0,1 mm

SPRAY PROCEDURE (Arc)

  Atomizing Air Pressure Nozzle Cap Arc Load Volt Ampere Stand off mm Coating thickness / pass mm/pass Deposit Efficiency %
Standard 1,6 3,5 bar   29-30 50-300 125-175 0,125 80%

SALES UNIT

Coil "BS 300" = 15 kg "BS 450" = 25 kg Other dimensions on request
Wire diameter 1,6 mm (1/16") 2,4 mm  

Corodur Fülldraht GmbH may change the characteristics of the wire without notice. Statements on composition and application are just for the applier’s information. Statements on mechanical properties always refer to the all-weld-metal according to valid standards. We recommend the applier to check our products for their special application autonomously

PDF Factsheet