CORODUR® 476
CLASSIFICATION
DIN EN 14700 DIN 8555
T Z Fe7 MF 5-50-PRT
GENERAL CHARACTERISTICS
CORODUR 476 is a high Cr- Ni- Mo- Co- V- W- alloyed flux cored wire. It was especially developed for the hardfacing of rolls for hot rolling. The weld deposit is corrosion and wear resistant. Furthermore it is resistant to impact loads and continuous rating through heat effect and high pressure. The hardfacing should be done in 2 - 3 layers. The finished layer should be 5 mm. The interpass
temperature should not exceed 450°C.
APPLICATION
steel mill rolls
TYPICAL ALL WELD METAL ANALYSIS ( % ):
C | Si | Mn | Cr | Ni | Mo | Co | V | V |
0,3 | 0,3 | 0,8 | 16,0 | 4,0 | 1,5 | 1,0 | 1,0 | 1,0 |
TYPICAL ALL WELD METAL MECHANICAL PROPERTIES
Hardness 48 - 50 HRc
PARAMETER
Diameter | Voltage | Amps |
1,2 | 20-24 | 150-200 |
1,6 | 22-26 | 180-240 |
2,0 | 25-27 | 220-260 |
2,4 | 25-27 | 260-300 |
2,8 | 26-28 | 280-340 |
FORMS OF DELIVERY
Coil "BS 300" = 15 kg | Coil "BS 450" = 25 kg | Drums = 300 kg |
Corodur Fülldraht GmbH may change the characteristics of the wire without notice. Statements on composition and application are just for the applier’s information. Statements on mechanical properties always refer to the all-weld-metal according to valid standards. We recommend the applier to check our products for their special application autonomously.